Electrical Temperature Measuring Systems

When using digital soldering the calibration boxes WCB2 is used as the external input unit for programmiing additional functions. The setting is fast and easy. Battery power supply makes the boxes independent from any mains and easy to transport. Consits of calibration box, batteries 4 x 1.5V, operating instruction. Additional functions for WCB2

New calibration of soldering station and factory settings, temperature measures with thermoelement type K and measuring tip. A differance between set and read temperature can directly corrected with the offset function. All popular digital Weller soldering stations can be programmed by the WCB1 and WCB2 programme modules to provide:

Single temperature lockout

Temperature range lockout

Timed temperature set-back to extend tip-life

Display in Farenheit or Celcius

Automatic shutoff and tip mass offsets 04/06 jj

CLICK FOR SPARES AND ACCESSORIES

For further information and PDFs Click Here

When using digital soldering the calibration boxes WCB1 is used as the external input unit for programmiing additional functions. The setting is fast and easy. Battery power supply makes the boxes independent from any mains and easy to transport. Consits of calibration box, batteries 4 x 1.5V, operating instructions. All popular digital Weller soldering stations can be programmed by the WCB1 and WCB2 programme modules to provide:

Single temperature lockout

Temperature range lockout

Timed temperature set-back to extend tip-life

Display in Farenheit or Celcius

Automatic shutoff and tip mass offsets

CLICK FOR SPARES AND ACCESSORIES 04/06 jj
For further information and PDFs Click Here

The WTT 1 is designed for low mass minature soldering iron tip measurements. It does not heat sink the measured item. The probe has its own internal heat source and duel sensor system that measures both temperatures and heat flow.It provides accurate measurement in less than 10 seconds. Temperature measurement and calibration, measures temperature without imposing thermal load. The WTT1 digital temperature system has been specifically designed for measuring the temperture of soldering iron tips. The probe has dóuble sensor system and internal heat source. The measured temperature is fed to a control that records the flow of heat in the probe and stablizes it with the aid of the internal heat source. This design ensures that no heat is drawn by the probe from the object being measured. Erroneous measurements due to the large thermal load of the probe are thus prevented. The measured temperature is indicated on a 3 digit LED display to a resolution of 1c. An adjustable preheat temperature ensures a rapid response even at high temperatues 08/07 jj
Click for bigger image
For further information and PDFs Click Here