Includes longer lever for increased leverage ratio over standard 502 PanaPress, crimp die holders, all mounting hardware and two allen wrenches to ease installation. Only tool required to complete installation is a medium flat blade screw driver. Special needle point allen screws, align crimp dies in upper and lower die holders. More effective than hand crimpers (completely eliminates the "scissors effect") for about the same cost, the 561 Crimp Press Retrofit Kit will accept your current crimp dies, and accepts standard industry die sets. The 12" (304.8mm) lever provides a 20:1 leverage ratio that makes the press easy to use while helping to prevent injuries to the wrist, hands, nerves and tendons. Perfect for in-house service departments, independent technicians and medium-volume manufacturing operations. 05/05 jj Click for bigger image |
 |
Precision ground ram is 3/4" x 3/4" (19.1mm x 19.1mm) and 5 7/8" (149.2mm) long. hole in ram? Four adjustable nylon gibs provide exceptional ram control. Lever arm is 8" (203.2mm) long. Base footprint is 3.7" (94mm) x 7" (177.8mm) Holes 1/4" (6.3mm), countersunk 7/16" (11.1mm) are located at all four corners for bolting to the work surface. Two additional holes are drilled in base plate and screws provided of XX size for attaching tooling or for attachment of 506 IDC Bench Assembly Press Retrofit Kit or 561 Crimp Press Retrofit Kit. The slot? Weighs 5 lbs. 7 oz. (2.5 kg) and stands 7" (177.8mm) high (not including 8" (203.2mm) arm or ram height). 05/05 jj Click for bigger image |
|
Includes shorter lever than standard 502 PanaPress for full lever motion without striking top plate, ribbon cable guide, all mounting hardware and wrenches for ease of installation. Only tool required to complete installation is a medium phillips screw driver. More effective than hand crimpers (completely eliminates the "scissors effect"). This easy to use IDC Bench Assmebly Press helps prevent injuries to the wrist, hands, nerves and tendons. Interchangeable base plates and flat ribbon cable cutter are available. Perfect for independent repair technicians, in-house service departments and value added cable houses; recommended for low volume, mass termination of various IDC connectors on flat ribbon cable. 05/05 jj POA Click for bigger image |
|
Flat Ribbon Cable Cutter - Model 507 The Model 507 Flat Ribbon Cable Cutter will deliver consistent right-angle cuts on cable up to 64 conductor cable. The Cutter easly slips in and out of the 506 IDC press in seconds. Better then using scissors, as there is no pulling on the inner wires. 05/05 jj Click for bigger image |
|
|
|
|
|
|
|
|
|
Replacement blades fit the Model 507 Flat Ribbon Cable Cutter. Three blades are included in each package. 06/03 JJ 05/05 jj Click for bigger image |
|
The replacement guide arm is identical to the guide arm that comes in the Model 506 Retrofit Kit. The use of two guide arms on the 506 Retrofit Kit is prefered by some users versus one for added cable alignment. 05/05 jj Click for bigger image |
|
